WIKA

Continuous measurement

Detect fill levels continuously at any time

Our level sensors enable the continuous detection of levels, independent of physical and chemical changes of the media such as foaming, conductivity, dielectric, pressure, vacuum, temperature, vapours, condensation, bubble formation, boiling effects and density change. Via the HART® interface, parallel measurement of interface layer and overall level is possible. The level can be displayed proportional to height or volume. Process connection, guide tube and float can be manufactured from stainless steel 1.4571, 1.4435, 1.4539, titanium or various plastics.

FAQ
FAQ

What happens after the minimum validity of the WIKA Build ID has expired?

Validity cannot be guaranteed after three months.

What is a magnetostrictive level sensor used for?

These level sensors are used as measured value pick-ups for the continuous recording of levels, and are based on determining the position of a magnetic float according to the magnetostrictive principle.